OZDAT
http://www.ozdat.com.au/forum/

H190 Diff Centres
http://www.ozdat.com.au/forum/viewtopic.php?f=2&t=34821
Page 1 of 1

Author:  JeffS620 [ Wed Oct 31, 2018 4:06 pm ]
Post subject:  H190 Diff Centres

HI All......Looking for a more highway friendly diff centre, for my Datto 620 project......happy for any advise, direction, or alternative suggestions of where I can get my hands on diff centre, that ratio starts with a 3 ??.....Happy to swap /sell the current 4.6 centre..........I only have 3 Datsun 620's, but hoping to expand my collection LOL

Author:  green200b [ Wed Oct 31, 2018 7:07 pm ]
Post subject:  Re: H190 Diff Centres

They're getting thin on the ground at wreckers yards now but probably the easiest way to find one would be to get one from a series 3 Bluebird. They are mostly 3.9:1. I'm not sure if the axle spline count is the same but worst-case you could take both diff centres to a diff shop and get them to switch the ratios over.

Author:  JeffS620 [ Fri Nov 02, 2018 3:08 pm ]
Post subject:  Re: H190 Diff Centres

Thanks Green 200B......shall look at local wreckers....like you say, they are scarce nowdays ?.......bit like rocking horse do do

Author:  d [ Wed Nov 14, 2018 12:21 am ]
Post subject:  Re: H190 Diff Centres

Just in case you dont find one I can get a 3.7 R&P from a local wreckers here in Japan
they pull them out inspect etc. for me but once you do the conversion rate they are
about $250 aud plus postage which is about 70aud. Just in case you are stuck as a
datsun 1200 ute I supplied uses a Z24 cranked L series that now revs well on the Hwy.

Author:  JeffS620 [ Thu Nov 15, 2018 11:31 am ]
Post subject:  Re: H190 Diff Centres

Thanks d, for your information......sounds like a plan....I have got onto a 3.9 diff centre from a Datto guy in Victoria.....(off facebook, Datsun site)......same price as you are quoting, and who knows the postage ??........but he seems to have gone cold /quiet ?.....no reply ?..........can you pm me, with your contact number, so I can arrange ?.......Cheers, Jeff

Author:  JeffS620 [ Fri Dec 14, 2018 9:36 am ]
Post subject:  Re: H190 Diff Centres

HI D......wondering if you can give me your contact number please ?.....would like to chat about getting an imported centre ?......Cheers, Jeff

Author:  d [ Fri Dec 21, 2018 12:41 pm ]
Post subject:  Re: H190 Diff Centres

JeffS620 wrote: *
HI D......wondering if you can give me your contact number please ?.....would like to chat about getting an imported centre ?......Cheers, Jeff
Gday Jeff, sending you my contact details via PM
Sorry for late reply, page has been down

Page 1 of 1 All times are UTC+11:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/