What is the go with these cam's.I have no adjustment on my rockers.I have done a couple of searches on this site and nothing comes up.If anyone can point me in the wright direction for info that would be much appreciated.

cheers

_________________
Yes! I'm another Datsun sicko.

Whats the problem?
Do you have the cam #
What lash pads are you using?

_________________
A little knowledge is a dangerous thing.
www.datsport.com

"R.I.P. Baz. 29 April 2022. Thank you for all your contributions to the Datsun community over the years. You will be missed." - OZDAT

Sorry about the delay my shed is 250kms from where I live. Anyway the numbers are 27/59, So what does that tell us Baz?

_________________
Yes! I'm another Datsun sicko.

I could speculate, but it would not help.
that is not the RB cam id# that i am used to.
Are you sure its an RB cam?
You will need to check the valve geometry,
sounds like the valves are too deep in the head or wrong lash pads.

_________________
A little knowledge is a dangerous thing.
www.datsport.com

"R.I.P. Baz. 29 April 2022. Thank you for all your contributions to the Datsun community over the years. You will be missed." - OZDAT

The motor was running sweet until I decided to pull it down and check everything.I replaced a couple of the lash pads with some I had lying around and thats when I noticed that I could not adjust them accurately.

I found that id # on the back of the cam, as it was in already I did not see any other numbers. Where do you normally see the id # and how many digits are they?

yours eagerly awaiting any help as I want to do hill climbs with this motor asap.

cheers

_________________
Yes! I'm another Datsun sicko.