I have a CA18 loom so was hoping to keep it with the ca sensor i have bought. Might have to find someone switched on at a tuning place who will be able to tune with Wolf too. Is there a link to your photo and any other info? Trying to determine if it matters which way sensor runs as there are 4 cut outs at 90 degrees from small to large. Or changing theoretical order of firing by changing wiring to suit what the computer is seeing.
http://www.performanceforums.com/forums ... oupe/page6
From memory the ca18 disc does need to be flipped when put on an L series distributor base. Dan (http://www.ozdat.com/forum/memberlist.p ... file&u=226
) did the conversion on a guys Z18 in NZ, ca18det ecu with nistune etc etc using a ca18 cas on a 6 cylinder L series base installed on a Z18.
I used to have an article writeup on my old site but it got lost when the web hoster went down.