hey guys, i have 2 saas mach II fixed racing seats. had them a while. want to know if they will fit into a datsun ute..?
i have some mesurements; give or take a lil bit lol




That 2nd pic at the back where it says 820mm, thst is mesured from top of seat STRAIGHT down onto the floor, Not on a angle.

thanks alot, Ben.

I don't like your chances
The cabin at shoulder level is only 1250mm wide.
If those seats are 610mm wide, then they will be near as dammit touching the doors and each other
The other dimensions are reasonable.
I have Skyline seats in my B120 and they are snug enough.
They are 510mm at their widest point, just above the waist line.
Another limitation when fitting modern seats to the Ute is the fore aft adjustment.
You may find that even with the seat firmly against the rear panel you will still be sitting up like Jacky with the steering wheel close to your bod.
If the seat has minimum padding then that problem diminishes a little.

_________________
Regards, Graeme
Just trying to help...
http://nissanman.shutterfly.com/
graemes@internode.on.net

Thanks mate.

Well were it is 610mm, they bend in if you you get me. there and thats 610 from the very widest of the guards. and they come out a bit.

What skyline are they out of?

_________________
Sam-U-El/Racer135
1973 B110 - http://ozdat.com/forum/viewtopic.php?f=60&t=21539
1972 B110
1978 120Y sdn
1973 B120 - dead
1971 VB110 4dr - sold
Others:
1995 Proton Wira - daily sh#tbox