building an efi L20 turbo currently
need to setup the turbo oil feed, ive figured out i should run it from the where the oil pressure sender is off another T peice, should i use a high temp braied line? where to get these and what fittings to they use?
and then the turbo drains back to the sump correct
thanks

i went to pirtek and had a new high-temp braided line made up for my z18et. used the original end fittings. you'll have to fabricate something that bolts up to the oil inlet on the turbo.

then run a return line to the sump. again, you'll have to fabricate something that bolts up to the oil outlet.

or go to the wreckers and look for a car with a similar turbo and grab the oil lines off that

_________________
1971 Datsun 1600 - Z18ET
1996 Suzuki RGV250 VJ22
1996 Suzuki RGV250 SP VJ23