Hi guys,

I live around the Morley area but I can go as far as Malaga and I'm looking for a decent panel beater to rebuild the bottoms of my 180b doors. They have rusted through quite badly and the outer lip on the bottom of the doors needs a lot of attention. I also need a little bit of rust busting around the welds below my rear lights.

Any recommendations?

P.s. The reason I can only go as far as Malaga is due to over heating. I'd rather not as the gridlock on the way home gets me right on H and I worry about this. Close to Morley is preferred.

Regards,

Chris

_________________
Datsun 180b Bluebird. 1974 Auto 4 door GL.

I would recommend Gary @ Malaga Rust Repairs.. he did a thorough job of the rust repair on my 1600.

He takes pics of all his work from start to finish and gives it to you on a CD too so you can see just what he's done.
Covers his butt too.

I would also recommend a bottle of chemi-weld, that sh*t rocks

_________________
1x tar baby 1x rally baby 1x project

I'll second Gary @ Malaga Rust Repairs 9248 1820 top bloke top work reasonable priced.

_________________
Regards
DEZA
OzDat WA President

76 180B Wagon FJ20e, LT8 -daily
83 DR30RS FJ20et, GT35/40, 45mm Turbo Smart waste gate, 35mm Sard BOV, 356rwhp @ 19psi.

GO HARD or GO HOME, GO SIDEWAYS or GO SQUARE

Thanks guys, I'll give him a try

Does he do prep and spray work too (ie, the bonnet and a couple of dings)?

_________________
Datsun 180b Bluebird. 1974 Auto 4 door GL.

He dose the prep work and has someone else do the paint.

Another one to try is Gasses Industies in wangara he loves his datto too sorry I don't have his number but choonk will.

_________________
Regards
DEZA
OzDat WA President

76 180B Wagon FJ20e, LT8 -daily
83 DR30RS FJ20et, GT35/40, 45mm Turbo Smart waste gate, 35mm Sard BOV, 356rwhp @ 19psi.

GO HARD or GO HOME, GO SIDEWAYS or GO SQUARE