Thanks for your comments guys! Also Jamie not sure if you knew or not but I'm Datto_610 from the NZ Datsun forum. I have my adjustable front suspension pretty much sorted now and man its low! The engine crossmember is roughly 113mm off the ground at the lowest adjustment on the sleeve. In NZ the lowest we can legally go is 100mm off the ground from the crossmember. I have 205/65/15's on at the moment but will be most likely be running 195/55/15's when I get the wheels I want to run which might bring it down a tad more. I took a shot of how low the front is at the moment no doubt I'll end up raising it a bit but thats fine with me. I wont get the sleeves welded onto the strut yet until I get the wheels and tyres I want to use then I'll double check everything.
That 90 degree steel bend is for a custom dump I'm going to have made. The factory CA pipe was rather close to the idler arm I probably could've gotten away with using it but just wanted to be safe.