| OZDAT http://www.ozdat.com.au/forum/ |
|
| Lower section of front guard-1600 http://www.ozdat.com.au/forum/viewtopic.php?t=25774 |
Page 1 of 1 |
| Author: | sixteen510 [ Thu Jun 09, 2011 7:58 pm ] | ||
| Post subject: | Lower section of front guard-1600 | ||
Hi guys, i would like to know if anyone has actually made a replica of the lower section of the front guards. I understand it is simple to make most of it except the wheel arch as it is round and has a slight curve in it. Sorry if this has been covered before but i wasn't sure what to search 
|
|||
| Author: | bradleyDaley93 [ Thu Jun 09, 2011 8:03 pm ] |
| Post subject: | Re: Lower section of front guard-1600 |
i can make them at work, |
|
| Author: | Dave [ Thu Jun 09, 2011 8:39 pm ] |
| Post subject: | Re: Lower section of front guard-1600 |
Rare Spares have |
|
| Author: | sixteen510 [ Thu Jun 09, 2011 9:41 pm ] | |
| Post subject: | Re: Lower section of front guard-1600 | |
I can make them at work,
How do you bend the small flared part?Dave- i was looking for a cheaper option, im just practicing on some old guards |
||
| Author: | bradleyDaley93 [ Thu Jun 09, 2011 9:43 pm ] |
| Post subject: | Re: Lower section of front guard-1600 |
on our massvie folder, with little cuts, then weld it up and grind smoth |
|
| Author: | sutho510 [ Thu Jun 09, 2011 9:59 pm ] | |
| Post subject: | Re: Lower section of front guard-1600 | |
on our massvie folder, with little cuts, then weld it up and grind smoth
i brought one of ebay it was hand made cost $60 and was one piece with no cuts or welds he shrunk the edgeit was a really good job |
||
| Page 1 of 1 | All times are UTC+11:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|