| OZDAT http://www.ozdat.com.au/forum/ |
|
| stanza booster/master http://www.ozdat.com.au/forum/viewtopic.php?t=29135 |
Page 1 of 1 |
| Author: | stanzaaa [ Wed Jul 04, 2012 7:19 pm ] |
| Post subject: | stanza booster/master |
hey guys i noticed this master on datsport doesnt have the fluid level sensor. is that a problem? if thats the case then why shouldnt i just buy this one off ebay? http://www.ebay.com.au/itm/DATSUN-NISSI ... 48458cff5a see how my one does (bottom pic) http://www.datsport.com/hydraulic-brake ... der78.html ![[ img ]](http://i50.tinypic.com/2yvs6xv.png)
|
|
| Author: | OLDATO [ Wed Jul 04, 2012 8:21 pm ] |
| Post subject: | Re: stanza booster/master |
The datsport link you show has a booster attached. The ebay link is just for the master which is like this : http://www.datsport.com/hydraulic-brake-master-78.html Also on ebay for more here : http://www.ebay.com.au/itm/Brake-Master ... 2318a8e9ed The one you listed is for an N10 cherry - don't know if it will work on a Stanza A10 |
|
| Author: | stanzaaa [ Wed Jul 04, 2012 9:42 pm ] |
| Post subject: | Re: stanza booster/master |
thanks but i was asking about the dash brake light connector. ive figured it out now. its a screw on bit. thanks anyway. |
|
| Author: | stanzaaa [ Wed Jul 04, 2012 11:25 pm ] |
| Post subject: | Re: stanza booster/master |
Another question I have is the face that the datsport ones only have 2 brake line outlets. How do I route fluid to all 4 calipers if I do this. Does that mean I have to get new brake like too? |
|
| Author: | OLDATO [ Thu Jul 05, 2012 1:16 am ] |
| Post subject: | Re: stanza booster/master |
Check the datsport description "available as disk/disk or disk/drum please specify when ordering" Give Baz at datsport a call tomorrow if in doubt, he is always helpful |
|
| Author: | Baz [ Thu Jul 05, 2012 10:43 am ] |
| Post subject: | Re: stanza booster/master |
The master cylinder you have is a PBR , these were fitted to Australian production vehicles, except CKD versions. They are not interchangable with Jap spec master cylinders. |
|
| Author: | AYJAY [ Thu Jul 05, 2012 2:38 pm ] |
| Post subject: | Re: stanza booster/master |
Baz how do the PBR m/c's go with rear disks? Do they have the residual pressure valve in the rear line? |
|
| Page 1 of 1 | All times are UTC+11:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|