With the wheel off you should see a round hole at the top and bottom of both pads there is meant to be two pins that go from the inner to outer pad top and bottom and they have a small hole drilled in them to install a locking pin and that should hold it all together and stop your rattleing. I've try to send you pic but am new to this site let me know if it came through ok unfortunately my 120y is missing the same pins in the image. But I do know 80 modle pulsars used a similer setup on there brakes just not sure if the length or diameter is the same maybe you could find a set of anti rattle pins at a wreakers just make sure the pins are the diameter is the same as the holes in the pads measuerd mine and diamiter of the hole is 6mm and the outside from inner to outer pad was 35.85. keep in mind this mesurment is taken on new pads so that should give you an idea on the length pin you need hope this helps good luck.
| Attachments: |
|
image.jpg [ 950.25 KiB | Viewed 3837 times ] |
|
image.jpg [ 1.11 MiB | Viewed 3837 times ] |