Hi all.
Are there any differences in lengths for the 4 or 5 speed tailshafts for manual stanzas?

Also are they different for tge rear flange for h165 vs bw set ups ( im assuming the flange is different like most h and bw stuff)
I have a bw rear end in there now and looking at swapping the the h165 setup as its easier to either get a 2nd hand lsd or just a damn better ratio than 3.7

Any strength differences between them?

Bump???? Anyone got any info on these queries

Id say tailshafts are the same as they are both a short box....
You need to change the flange when you put a H165 in...

H165 is said to be stronger too.

_________________
1979 Datsun Stanza Coupe
1979 Datsun Stanza Coupe Project
1979 Datsun Stanza GX
1982 Datsun Stanza GX
1966 Nissan Cedric Custom Six
1972 Volkswagen Beetle
1974 Toyota Landcruiser Stallion (SWB)
EziAutoParts

I broke alot of diffs in my previous stanza's.
From my experience
H165 had a tougher centre, even if its open but poo axle's.
The BW was the other way around.

_________________
Dan.
Official organisor of Thursday nite pizza.

K. Cheers. So get a h165 for blowing axles and keep the for a good spare.

Are the axles equal length on the h165? So if break one just whack in another? No need to worry about drivers or passenger side specifically?

If you swap ANY axles drive direction it will have a greater chance of failing.

_________________
A little knowledge is a dangerous thing.
www.datsport.com

"R.I.P. Baz. 29 April 2022. Thank you for all your contributions to the Datsun community over the years. You will be missed." - OZDAT