OZDAT http://www.ozdat.com.au/forum/ |
|
tyre to spring pearch clearance http://www.ozdat.com.au/forum/viewtopic.php?t=33401 |
Page 1 of 1 |
Author: | unfamilia [ Wed Dec 24, 2014 6:33 am ] |
Post subject: | tyre to spring pearch clearance |
How much clearance is needed on the front for tyre to spring pearch clearance? This Is with coil overs 10mm? Running a 185 55 15 and just wondering due to tyre deflection under cornering etc. |
Author: | Jimmy351 [ Wed Dec 24, 2014 8:07 am ] |
Post subject: | Re: tyre to spring pearch clearance |
10mm should be plenty. When i had the 14 inch stock bluebird wheels I had maybe 3mm on one side and it didn't hit (also with coil overs). The 15's I run now have a bit more clearance as I got +12 to space them out a bit. |
Author: | unfamilia [ Wed Dec 24, 2014 10:00 am ] |
Post subject: | Re: tyre to spring pearch clearance |
These are z 31 wheels and 30 offset. Last ones were 20 offset. |
Author: | Nissanman [ Wed Dec 24, 2014 10:43 am ] |
Post subject: | Re: tyre to spring pearch clearance |
Being at the top of the tyre, I wouldn't expect any deformation from cornering. If it clears by 1mm, it clears by 1mm! Any polished areas will tell the tale |
Author: | unfamilia [ Wed Dec 24, 2014 11:14 am ] |
Post subject: | Re: tyre to spring pearch clearance |
It's right smack bang in the middle. Between the sidewall bead and start of the tread casing |
Author: | unfamilia [ Wed Dec 24, 2014 4:04 pm ] |
Post subject: | Re: tyre to spring pearch clearance |
Author: | Jimmy351 [ Wed Dec 24, 2014 4:13 pm ] |
Post subject: | Re: tyre to spring pearch clearance |
That's about what I had with the old wheels, if it doesn't hit when on the ground it will never hit I don't think... All the tyre change under load is where the tyre meets the road. |
Author: | unfamilia [ Wed Dec 24, 2014 6:38 pm ] |
Post subject: | Re: tyre to spring pearch clearance |
Investigating shorter spring options now. will lift the pearch up one to 2 inches at least |
Author: | Baz [ Wed Dec 24, 2014 9:43 pm ] |
Post subject: | Re: tyre to spring pearch clearance |
That kink in the brake hose doesn't look good. |
Author: | unfamilia [ Wed Dec 24, 2014 10:36 pm ] |
Post subject: | Re: tyre to spring pearch clearance |
Braided lines on the front. I font know why they do It but at turn they see fine I'm straight ahead like that. I'm not sure what previous owner after simon in act did??? |
Page 1 of 1 | All times are UTC+11:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |