Are all h 190 diff flanges same? between navara and gazelle and bluebird?

My new center has potentially a navara flange. Need to know if the all the same to try find all tail Shaft to fit the stanza. obviously will most likely need shortening etc.

H165 flange is similar as well and works on h190 apparently I have been told

Ok Shaft I cam get has a flange spacing of 70mm diagonally for the mounting holes.
My diff flange has spacing of 72mm diagonally.

Anyone know what diff or tail Shaft has a 72mm mounting hole spacing?

Gazelle have a long pinion flange and different bolt spacing, ive seen long type on vans also but cant confirm PCD. These have holes that aren't all equally spaced like a bluebird one i believe. I could go out n measure to be sure

This is early type flange
my old h190 s12 flange Is identical with 70mm diagonal hole spacing. Measuring replacement center flange it's 72mm

Reading Internet says could be post 86 datsun 720 flange but I thought should ask here.
I can't swap flanges from one center to other cause will stuff preload etc on new center.

I need to get a tailshaft to suit my stanza so if I can find out what car to get the 72mm tail Shaft from, I can get it shortened to suit.

New flange looks almost identical but holes are 72 mm even spacing on a round flange.

post 86 720 would be c200

Not being silly, but tried rotating 90degrees and lining up holes?

Will try during week.

here is bluebird diff I'm getting tail Shaft from
Apparently 70mm diagonal hole spacing


Here is the flange that is fitted to my diff. 72mm diagonal and square 50 x50 mm flange ppattern


here is the flange on the s12 h190 center that was In diff. 40 x50 mm rectangle flange 65-66mm diagonally.

My digital calipers don't work anymore since being left In rain sorry.