OZDAT http://www.ozdat.com.au/forum/ |
|
Replacement master cylinder - 180b http://www.ozdat.com.au/forum/viewtopic.php?t=34043 |
Page 1 of 1 |
Author: | batesy72 [ Mon Dec 07, 2015 7:59 pm ] |
Post subject: | Replacement master cylinder - 180b |
Hi guys, I have a Girlock master cylinder on the car at present but it seems near impossible to get a replacement with the brake line outlets on the left hand side of the master cylinder body. All the replacement bodies I come across have brake lines attached underneath. Any suggestions? I tried honing out the dodgy piston/bore in the set-up but no go. I was going to buy a rebuild kit but it seemed cheaper buying the whole master cylinder ... well, it did until I got quoted $330 for the right cylinder! |
Author: | Nissanman [ Mon Dec 07, 2015 9:34 pm ] |
Post subject: | Re: Replacement master cylinder - 180b |
You can get the original M/C bored and sleeved with a stainless steel sleeve. That way the cylinder will last "forever" and the standard rebuild kit will apply |
Author: | batesy72 [ Tue Dec 08, 2015 6:28 am ] |
Post subject: | Re: Replacement master cylinder - 180b |
Thanks Graeme. Sounds like a good idea. I'll go and do that. |
Page 1 of 1 | All times are UTC+11:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |