OZDAT http://www.ozdat.com.au/forum/ |
|
Balance tube on single dcoe? http://www.ozdat.com.au/forum/viewtopic.php?t=34453 |
Page 1 of 1 |
Author: | skitzone [ Mon Feb 06, 2017 12:03 am ] |
Post subject: | Balance tube on single dcoe? |
Fitting a single dcoe to a mates motor came off a warm l18 last use ran pretty well from memory. Been reading up about the cylinder 1/4 lean issue with a single. Is it worth drilling and adding two 3/8 ID elbows and a hydraulic line between them? |
Page 1 of 1 | All times are UTC+11:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |