| OZDAT http://www.ozdat.com.au/forum/ |
|
| r200 output shaft question http://www.ozdat.com.au/forum/viewtopic.php?t=34910 |
Page 1 of 1 |
| Author: | FJ20DET1600 [ Sat Oct 12, 2019 10:21 am ] | ||
| Post subject: | r200 output shaft question | ||
Hi guys, Wondering if anyone can help, Iv got my diff out at the moment and noticed the output flange "wobble" (up and down) around 3mm. The splined surface of the shaft looks fine but the load-carrying surface looks worn. Does anyone know the nominal OD of the surface shown in the pic?
|
|||
| Author: | RJB510 [ Fri Oct 18, 2019 7:55 am ] |
| Post subject: | Re: r200 output shaft question |
What's the other side like? Are your bearings ok? First, what centre is it? Mine is S15 and it runs a 30mm diff stub axle. I think some others are around 29.6mm and gtr is bigger than them all, 31mm or so. That axle also looks like a maddat cv coverted stub axle? Ive not seen one like that from factory before. Got a closer pic? |
|
| Page 1 of 1 | All times are UTC+11:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|