OZDAT
http://www.ozdat.com.au/forum/

Replacement hubs
http://www.ozdat.com.au/forum/viewtopic.php?t=34934
Page 1 of 1

Author:  Datdabbles [ Mon Apr 20, 2020 12:30 pm ]
Post subject:  Replacement hubs

Hi I'm finishing up my 510 rally car and noticed the wheel studs have been stripped and welded on, some welds broken. I don't have a lot of money to spend and wanted to know either where I could get some replacement hubs or if any newer model Nissan hubs will fit? The studs and hubs look stripped to me.

Author:  sutho510 [ Tue Apr 21, 2020 7:25 pm ]
Post subject:  Re: Replacement hubs

Hi do you know what struts are on the car?

Author:  Datdabbles [ Wed Apr 22, 2020 7:32 am ]
Post subject:  Re: Replacement hubs

Not too sure but here's a pic?

Attachments:
[ attachment ]
IMG_20200411_143122_626.jpg [ 1.05 MiB | Viewed 9468 times ]

Author:  Dave [ Wed Apr 22, 2020 9:54 am ]
Post subject:  Re: Replacement hubs

Hard to say what they are, but they aren't 1600 hubs. Could be 240K ?? Got a picture of the brake caliper, might be easier to work it out from that as a lot of hubs look the same.

Author:  Datdabbles [ Thu Apr 23, 2020 10:23 am ]
Post subject:  Re: Replacement hubs

Here you go

Attachments:
[ attachment ]
IMG_20200413_143351_226.jpg [ 1.62 MiB | Viewed 9452 times ]

Author:  Dave [ Thu Apr 23, 2020 2:15 pm ]
Post subject:  Re: Replacement hubs

They look like they could be 200B brakes ? Been a while since I've seen 200B brakes up close, but they look vaguely how I remember them. If that's the case, I would assume your hubs are 200B as well ? Hopefully someone else can confirm ?

Author:  Datdabbles [ Fri Apr 24, 2020 11:26 pm ]
Post subject:  Re: Replacement hubs

Thanks mate, that would make sense as I was told the engine was from a 200B.

Author:  nick [ Sat Jun 06, 2020 10:25 pm ]
Post subject:  Re: Replacement hubs

They look like 200B Girlock calipers. Measure up the rotor to be sure and just get some more hubs from someone wrecking a car...

Page 1 of 1 All times are UTC+11:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/