Ozdat Home Feature Cars Ozdat Classifieds Event Calander Links Trade Link Tech Resource Merchandise Donate Web Mail
It is currently Fri Nov 01, 2024 12:00 pm

Unanswered topics | Active topics


» »

All times are UTC+11:00



Post new topic  Reply to topic  Page 1 of 1
  [ 4 posts ] 
  Print view Previous topic | Next topic 
Author Message
Guest
PostPosted: Sun Jun 08, 2003 11:10 am 
is this absolutly nessesary or do they still go on with a bit of a strugle.
Top
   
Reply with quote  
datsunboy
 Post subject:
PostPosted: Sun Jun 08, 2003 11:18 am 
Offline
User avatar

Joined: Fri May 16, 2003 7:47 pm
Posts: 899
Location: New Zealand
well......I've never done the conversion before....but I've read a few places...and never heard anything about that....so you probably don't...they should bolt staight up
Top
   
Reply with quote  
guest
 Post subject:
PostPosted: Sun Jun 08, 2003 2:18 pm 
yes, i'll post a link later. Try looking at Datnets tech section...
Top
   
Reply with quote  
Chris G
 Post subject:
PostPosted: Mon Jun 09, 2003 6:17 am 
Offline
User avatar

Joined: Wed Mar 05, 2003 8:46 am
Posts: 392
Location: Melbourne, Victoria, Australia
The centre hole of the disk needs about 1-2mm enlargement. Use either a diegrinder or a drill with a stone or rotary file.

Cheers,

_________________
Chris [;-{)>
Top
   
Reply with quote  
Display posts from previous:  Sort by  
Post new topic  Reply to topic  Page 1 of 1
  [ 4 posts ] 

» »

All times are UTC+11:00

Who is online

Users browsing this forum: No registered users and 0 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: 

Powered by phpBB® Forum Software © phpBB Limited