OZDAT https://www.ozdat.com.au/forum/ |
|
Replacement hubs https://www.ozdat.com.au/forum/viewtopic.php?t=34934 |
Page 1 of 1 |
Author: | Datdabbles [ Mon Apr 20, 2020 12:30 pm ] |
Post subject: | Replacement hubs |
Hi I'm finishing up my 510 rally car and noticed the wheel studs have been stripped and welded on, some welds broken. I don't have a lot of money to spend and wanted to know either where I could get some replacement hubs or if any newer model Nissan hubs will fit? The studs and hubs look stripped to me. |
Author: | sutho510 [ Tue Apr 21, 2020 7:25 pm ] |
Post subject: | Re: Replacement hubs |
Hi do you know what struts are on the car? |
Author: | Datdabbles [ Wed Apr 22, 2020 7:32 am ] | ||
Post subject: | Re: Replacement hubs | ||
Not too sure but here's a pic?
|
Author: | Dave [ Wed Apr 22, 2020 9:54 am ] |
Post subject: | Re: Replacement hubs |
Hard to say what they are, but they aren't 1600 hubs. Could be 240K ?? Got a picture of the brake caliper, might be easier to work it out from that as a lot of hubs look the same. |
Author: | Datdabbles [ Thu Apr 23, 2020 10:23 am ] | ||
Post subject: | Re: Replacement hubs | ||
Here you go
|
Author: | Dave [ Thu Apr 23, 2020 2:15 pm ] |
Post subject: | Re: Replacement hubs |
They look like they could be 200B brakes ? Been a while since I've seen 200B brakes up close, but they look vaguely how I remember them. If that's the case, I would assume your hubs are 200B as well ? Hopefully someone else can confirm ? |
Author: | Datdabbles [ Fri Apr 24, 2020 11:26 pm ] |
Post subject: | Re: Replacement hubs |
Thanks mate, that would make sense as I was told the engine was from a 200B. |
Author: | nick [ Sat Jun 06, 2020 10:25 pm ] |
Post subject: | Re: Replacement hubs |
They look like 200B Girlock calipers. Measure up the rotor to be sure and just get some more hubs from someone wrecking a car... |
Page 1 of 1 | All times are UTC+11:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |